Rose electronics Xtensys Manual de Instruções descarregar pdf (Página 43)

XTENSYS INSTALLATION AND OPERATIONS MANUAL

Appendix D. Quick Start Guide

The following guide will help you understand the basic single unit installation and operation procedures for the

Xtensys system. The Xtensys system consists of the Xtensys switch and a remote user station for each remote user.

The switch connects to your computers and to the remote user stations via CATx cabling. This greatly reduces cable

bulk and cost. Connecting keyboards, monitors, and mice to the remote user stations requires no additional cables.

These connect directly to the KVM station ports on the user station.

Refer to the below connectivity diagram when installing your Xtensys system. An Xtensys 8 x 32 model is used in

the below example. The basic installation is the same for all models.

To start the installation of the Xtensys system, it is recommended that all equipment (Xtensys switch, remote user

stations, KVM monitors, serial devices, and any other device) be powered off.

If powering off your servers and equipment is not feasible, refer to the Xtensys installation and operations manual for

the proper procedure to install the Xtensys system without removing power

Up to a total of 1,000 feet of CATx cable

The multi-platform feature of Xtensys allows you to connect PCs/servers, UNIX, SUN, Mac, Linux, or other systems

with no pre-configuration required. The PC port on Xtensys must be pre-configured only if a serial device is going to

be connected to that port.

The first item to assess is the topology or layout of the Xtensys switch, the computers, serial devices, the remote

user stations, and the CATx cable placement. Pre-planning of the layout of your switching system will make the

installation process go more smoothly. Decide which PC/server or serial device will be connected to each Xtensys

PC port (RJ45F rear connectors). Locate the Xtensys as close as possible to the computers and user stations so the

cables are as short as possible but still give some freedom of movement. Provide proper strain relief for all cables.

Following is a step by step guide for installing and operating a single unit installation.

Xtensys switch,

connect up to 64

servers or serial

devices

Connect up to 16

user stations to

an Xtensys switch

Standard

CAT5 cable

PS/2 or USB

KVM station

Xtensys

Transmitter

installed on each

connected

computer

PS/2 or USB

Transmitter

Standard

CAT5 cable

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Comentários a estes Manuais

Sem comentários

Rose electronics Xtensys Manual de Instruções Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Interruptores KVM Rose electronics Xtensys