Rose electronics UltraVista Manual de Instruções descarregar pdf (Página 55)

50 UltraVista Installation and Operations Manual

When you select “WRITE” the system is ready to read and save the added EDID/DDC information. Disconnect the

monitor from the video output connector and the video input connector. Connect a DVI cable from the video output

connector to the video input connector. When the cable is in place, press the “ENTER / SELECT” button twice. This

will program the unit with the additional EDID data. This procedure is performed blindly since the output monitor has

been disconnected. Wait a few seconds, and then remove the DVI cable from the video output and video input

connectors. Reconnect the video input cable from the video source and the video output monitor cable. The video

monitor should display the “CHANGE EDID/DDC/EDID” window with successful displayed and shown below.

If “successful” is displayed, the selected

video input has been successfully

programmed. Repeat this procedure for the

other video input in needed.

The configuration program “CONFDEV” can

also be used to program the EDID

information. This program runs externally on

a connected “Windows” computer connected

to UltraVista. This method allows you to

monitor the programming on the monitor.

1 2 ... 50 51 52 53 54 55 56 57

Sem comentários

Rose electronics UltraVista Manual de Instruções Página 55