Rose electronics UltraVista Manual de Instruções descarregar pdf (Página 19)

UltraVista LC Installation and Operations Manual 13

OSD Menu Structure

To reset the UltraVista LC to factory defaults, Press the “UP”,

“Down”, and “Enter” buttons simultaneously until the “Reset

to Mfg Default” message appears on the monitor connected

to DVI output connector #1.

Table 1 below shows the OSD menu structure.

Menu Options

Description

MASK Toggles the mask function ON /

OFF

X Sets the horizontal mask value*

Mask Control

Y Sets the vertical mask value*

LINK Toggles the link between the master

video unit’s mask value and the

slave’s value

Link Control

(2x2 and 3x3 only)

Scan Toggles the scan function ON / OFF

for detecting the attached slave

units

DVI Displays DVI output settings with

link on

Displays individual settings with

link off

X Sets the horizontal mask value

Slave Mask Setting

(2x2 and 3x3 only)

Y Sets the vertical mask value

OUT Sets the output resolution Settings

MODE Sets the output mode

Warning Change

Setting

Warning that the output resolution

OUT Displays the Units output resolution Information

IN Displays the Units input resolution

H Slave’s horizontal output resolution

Slave Output Resolution

(2x2 and 3x3 only)

V Slave’s vertical output resolution

SYNC Sync and Power

Power Turns the power on and off

FPGA FPGA chip version number

CPLD CPLD chip version number

Version Information

FW Firmware version number

Name Displays the model name Model Information

SN Displays the model serial number

* See page 8 for “X” and “Y” value calculations

Table 1. OSD Menu Structure

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Comentários a estes Manuais

Sem comentários

Rose electronics UltraVista Manual de Instruções Página 19

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Rose electronics UltraVista