Rose electronics UltraVista Manual de Instruções descarregar pdf (Página 7)

INTRODUCTION

UltraVista LC Installation and Operations Manual 1

Disclaimer

While every precaution has been taken in the preparation of this manual, the

manufacturer assumes no responsibility for errors or omissions. Neither

does the manufacturer assume any liability for damages resulting from the

use of the information contained herein. The manufacturer reserves the

right to change the specifications, functions, or circuitry of the product

without notice.

The manufacturer cannot accept liability for damages due to misuse of the

product or other circumstances outside the manufacturer’s control. The

manufacturer will not be responsible for any loss, damage, or injury arising

directly or indirectly from the use of this product.

System Introduction

The UltraVista LC is the product of choice for those who have the need to

produce a high quality, inexpensive video wall. Models are available for a

1x4, 2x2, and 3x3 video wall. The 2x2 and 3x3 models can be expanded to

produce a 4x4 or a 9x9 video array.

Connect the UltraVista LC directly to a laptop or desktop computer with a

single DVI cable and instantly the hi-definition computer image is displayed

on a large video wall. No extra set-up is required because the UltraVista LC

automatically detects the correct settings.

The UltraVista LC can be automatically configured to produce three output

modes; video wall mode, clone mode, and replication mode. These modes

are automatically configured based on the input resolution received from the

video source. The video wall mode accurately splits the input image over

the display array. The clone mode displays the same image on all monitors.

The replication mode shows the same image on each row of monitors.

Video Wall Mode Clone Mode Replication Mode

The UltraVista LC requires a high-resolution digital video input signal. This

input is split directly over the display array with no image scaling or

adjustments needed.

Configuring the UltraVista LC can be done from a built-in OSD menu

system, a computer connected to the RS-232 serial port or using the remote

control unit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Sem comentários

Rose electronics UltraVista Manual de Instruções Página 7