Rose electronics UC2-1x16U/E Manual de Instruções descarregar pdf (Página 37)

OPERATION

ULTRACONSOLE INSTALLATION AND OPERATIONS MANUAL 31

User operating instructions

The following instructions apply to all UltraConsole switches.

This section explains the operating functions of the on-screen displays, the login procedure, connect procedure and

other commands needed to easily use the UltraConsole switch and its capabilities.

To start using your UltraConsole switch, you first need to become familiar with the keyboard commands. The

available keyboard commands are shown in Table 1. All keyboard commands start with an attention sequence by

pressing and releasing the left [Ctrl] key, then the additional command characters. The additional command

characters must be entered within two seconds of each other or the command is aborted.

Commands are not case sensitive and are shown in upper or lower case for clarity only. Do not use the [SHIFT] key

or the numeric keypad to enter any commands. [Ctrl] in Table 1’s, Key Sequence column is a press and release

function of the left [Ctrl] key.

Keyboard commands

Command

Key Sequence

Description

Main Menu

[Ctrl] [F12]

Displays main menu

CPU List

[Ctrl] [Esc]

Displays CPU selection list

Direct CPU

connect

[Ctrl] n [Enter]

Connects directly to the specific

CPU number “n”.

Connect Back

[Ctrl] [Backspace]

Connects to the previous CPU

Connect Down

[Ctrl] [Minus sign]

Connects to the previous CPU

in a Group.

Connect Up

[Ctrl] [Plus sign]

Connects to the next sequential

CPU in a group

KVM Status

[Ctrl] D

Displays / Removes status box.

Logout

[Ctrl] L

Logs user out if the KVM station

is configured for user logins.

Disconnect

[Ctrl] Q

Disconnects the current CPU

Reset

Keyboard/

mouse

[Ctrl] R

Resets / enables keyboard and

mouse; enables PS/2 mouse on

connected CPU

Send Null Byte

[Ctrl] N

Sends a null byte to the CPU’s

PS/2 mouse port. Use this

command if the PS/2 mouse

gets “out of sync”.

Reset Mouse

(NT or Unix

systems only)

[Ctrl] O (not zero)

Resets the currently selected

NT or Unix computers PS/2

mouse. Also switches the NT

mouse driver to “wheel” mode.

Start Scan

[Ctrl] S

Sequentially steps through all

connected CPUs in a group.

Stop Scan

[Ctrl] X

Turns scan “Off”

Table 1. Keyboard commands

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Comentários a estes Manuais

Sem comentários

Rose electronics UC2-1x16U/E Manual de Instruções Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Interruptores KVM Rose electronics UC2-1x16U/E